The most common shield/sheath-bonding systems now in use on medium through extra high-voltage (5 kV to 500 kV) single-conductor shielded power cables and the methods of calculating the corresponding shield/sheath voltages and currents, when the cables are operated as part of a three-phase system, with the neutral grounded directly or through an impedance, are described in this guide.
- Standard Committee
- PE/IC - Insulated Conductors
- Status
- Inactive-Reserved Standard
- PAR Approval
- 2007-12-05
- Superseding
- 575-1988
- Board Approval
- 2014-06-12
- History
-
- Published:
- 2014-09-18
- Inactivated Date:
- 2025-03-27
Working Group Details
- Society
- IEEE Power and Energy Society
- Standard Committee
- PE/IC - Insulated Conductors
- Working Group
-
C02W/P575_WG - Bonding Metallic Shields of Single Conductor Power Cables Rated 69 - 500 kV Working Group
- IEEE Program Manager
- Dalisa Gonzalez
Contact Dalisa Gonzalez - Working Group Chair
- Michael Buckweitz
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
P575
Guide for Application of Sheath-Bonding Methods for Single-Conductor Cables and the Calculation of Induced Voltages and Currents in Cable Sheaths
This guide describes the most common special sheath-bonding systems in use on high-voltage, single-conductor, shielded power cables and methods of calculating sheath voltages and currents, particularly as applied to three-phase systems, with the cable neutral grounded directly or as part of a special bonding system as described in the guide. The guide reflects the latest industry practices.
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards